Determines the default display order and the display order inheritance of overlapping entities after they are created or modified.
Display order inheritance ensures that entities copied from other drawings maintain the display order from the original drawing.
Note: If the default display order is disabled, entities may not display correctly during editing sessions or during plotting.
Values
| 0 | Turns off the default display order of overlapping entities and display order inheritance. After editing or drawing an entity, the entity is displayed on top until either using the Rebuild command or reopening the drawing. The following commands are affected by display order inheritance: Split, Fillet, Hatch, EditHatch, Explode, Trim, Weld, EditPolyLine, and Offset. |
| 1 | Turns on the default display order of overlapping entities. After editing entities, they are automatically displayed in the correct display order. |
| 2 | Turns on display order inheritance. |
| 3 | Turns on the default display order of entities and display order inheritance. |
Properties
| Type | Integer |
| Range | 0 .. 3 |
| Default | 3 |
| Status | Read / Write |
| Saved | In the drawing |