Adjusting DGN Underlays

Use the AdjustDGN command to adjust the appearance of DGN Underlays against the graphics area background. You can adjust fade, contrast, and monochrome values. The settings do not affect the original file. When you print the drawing the settings are recognized.

To adjust DGN Underlays:

1. Type AdjustDGN at the command prompt.
2. In the graphics area, specify a DGN underlay and press Enter.
3. Specify options:
   • Fade. Sets the fade value. Values range between 0 (no transparency) and 100 (full transparency).
   • Contrast. Sets the contrast value. Values range between 0 (no contrast) and 100 (full contrast).
   • Monochrome. Specifies whether the underlay displays monochrome or with its original colors.

Note: The options for changing the appearance of the DGN underlay against the graphics area background are available on the DGN Underlay contextual ribbon tab.

If the ribbon is active, select a DGN underlay in the graphics area and control the appearance of the DGN underlay against the graphics area background from the DGN Underlay contextual ribbon tab.

Access

Command: AdjustDGN